Toshiba SD-M2012C Manual do Utilizador

TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-M2012C DVD-ROM DRIVE USER MANUAL

8 NOTE: Use a bar that is less than 1.5 mm in diameter. Do not insert more than 50mm in depth. Inserting more than 50mm may damage the DVD-ROM dri

9 TROUBLESHOOTING – SD-M2012C Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructio

10 SPECIFICATIONS –SD-M2012C General Interface ATAPI Media Compatibility CD 120mm CD-ROM (Read Only) 80mm CD (Horizontal Mount Only) 800/7

11 Burst Rate 16.7 Mbyte/s (PIO Mode 4) 16.7 Mbyte/s (multiple word DMA transfer mode 2) 33.3 MByte/s (Ultra DMA) Random Access Time CD-ROM 110

12 Power Consumption DC Voltage and Current Requirements 5V / 1.5A, 12V ; 1.5A +5V +12V Sleep Standby 400mA 500mA 100mA 300mA Physical Height 1.

13 DRIVE CONNECTORS –SD-M2012C Figure 1.SD-M2012C DVD-ROM Drive Rear Panel - Connectors Power Connector Power is supplied to your DVD-ROM drive

14 Table 1.Interface Pin Assignments INTERFACE PIN ASSIGNMENT PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME PIN NO. I/O SIGNAL NAME HOST SIGNAL NAME 1

CONTENTS Introduction...1 Setup ...

1 INTRODUCTION – SD-M2012C DVD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (eject button, software, emergency eject hole) A

CD • CD-DA • CD+(E)G • CD-MIDI • CD-TEXT • CD-ROM • CD-ROM-XA • CD-I Bridge (Photo-CD, Video CD) • CD-I • Multi-session (Photo-CD, CD

3 SETUP – SD-M2012C DVD-ROM The following steps must be performed to properly install your drive: • Set Drive Jumper Settings • Connect Audio Ca

4 Placing DVD-ROM Drive inside your Computer Now that you have set the jumpers, you are ready to install your DVD-ROM drive inside your computer. I

5 Audio Cable (optional) - If you have a sound card and speakers, and would like to play audio CDs on your computer, you will need to install a CD/DV

6 USING THE DVD DVD-ROM Drive – SD-M2012C Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontal

7 Removing a Disc To remove a disc from the DVD-ROM drive, perform the following steps: 1. Open the Loading Tray by pressing the Eject Button. 2.